Aluminum Etchant Type A
ALDRICH/901539
Synonym: Aluminum etching solution for use on silicon devices
Product Type: Chemical
This image is provided for informative purposes only and does not represent an actual product label. It should not be used as a substitute for official product labeling.
| form | liquid |
| Application: | • Aluminum metallizations up to 25,000 Å are vacuum deposited on the silicon slice, coated with a photoresist, and UV exposed using an appropriate photographic mask. The resist is developed to protect the aluminum where interconnections are desired. Then the unprotected areas of the aluminum are removed by etching with the aluminum etchant, followed by a water rinse. • Etching time is dependent upon the etchant temperature and the aluminum film thickness. When etching thick aluminum films, a higher etch rate is required; thus a higher etchant temperature should be used. Likewise, for thinner aluminum films, slower etch rates are desired and a lower etchant temperature should be chosen. • At a specific etchant temperature, the etching time is given by the following formula: Etching time (second) + Film Thickness (Å)/ Etch Rate (Å/sec) where Etch Rate at 25°C 30 Å/sec; at 40°C 80 Å/sec. |
| Features and Benefits: | • Controlled etch rates • Selective etching: will not attack SiO2 or Si3N4 • Offers high resolution with minimal undercutting • Eliminates smut formation • Economical; reusable |
| General description: | ALUMINUM ETCHANT - TYPE A • Standard aluminum etchant for use on silicon devices and other microelectronic applications. • Aluminum etchants are stable, non-toxic preparations used to etch aluminum metallizations on silicon devices and in integrated circuit applications. Aluminum contacts are defined, and interconnections are formed. These aluminum etchants, formulated with unique properties, easily overcome many of the difficulties experienced in aluminum etch processes. • The aluminum metallization and etching process using photo-lithographic techniques is basic to semiconductor and microelectronic technology. Aluminum etchants are highly compatible with commercial photoresists and permit delineation into high resolution patterns. Metal line width of 1 mil and separations less than 5 microns are feasible. High resolution is practical with these aluminum etchants because lifting of photoresist patterns does not occur and undercutting is minimized. Furthermore, the etchants do not attack silicon, silicon dioxide, silicon nitride or nichrome resistor films. • Two aluminum etchants are offered for use in microelectronics. Type A is recommended for use on silicon devices. Type D is recommended for use on gallium arsenide and gallium phosphide devices to avoid attack of the etchant on the intermetallic compound. It is also recommended for etching aluminum metallizations on nichrome thin film resistors. |
| Symbol |   GHS05,GHS07 |
| Signal word | Danger |
| Hazard statements | H290 - H302 - H314 |
| Precautionary statements | P234 - P270 - P280 - P301 + P312 - P303 + P361 + P353 - P305 + P351 + P338 |
| RIDADR | UN 3264 8 / PGII |
| WGK Germany | WGK 3 |
| Flash Point(F) | Not applicable |
| Flash Point(C) | Not applicable |
| Supplemental Hazard Statements | EUH071 |
| UNSPSC | 12352311 |